Stereo Receiver Turns Off At High Volume

Usually caused by a couple strands of speaker wire touching the wrong terminals on the back of the receiver. At the very least un hook one speaker at a time and turn the volume to the point that it normally shuts down.

Yamaha C 4 High End Vorverstarker Vorstufe Preamplifier In Schwarz Hifi Audio Vintage Electronics Hifi

Yep if you want really loud the Polks are a poor choice.

Stereo receiver turns off at high volume. Wiring Electrical Installation Help. Ive heard that this is caused by the internal amplifier trying to protect itself though Im not 100 certain. Amp Shuts Off at High Volume.

Every time it does it. My amp will play just fine at normal volumes but when I turn it past 25 or more on the head unit it will play maybe for a bit depending on the bass on the song. I used pac harness rp5-gm31 to retain everything.

Sometimes it will only take one or two speakers that are not rated at 8 ohms to shut down. Plug your device into a working wall outlet and not on a power strip or surge protector to reduce the possibility of a short circuit. Dec 28 2018 1 Ever since I.

If your speakers are 6 or 4 ohms your receiver is going to shut down at high volumes to protect itself. You need some thing about 10dB higher in electrical sensitivity. Also what are his speakers.

If my bass hits hard then it will go into protect mode. Well here it goesshuts down after a point when it gets to crazy levels. Now this phenomenon will usually happen after a little while on a higher volume.

Do not worry because you have us here. If they have low impedance 4 ohm they are harder to drive and may cause receiver to go into protection mode at high volumes. Speaker wire can be cheap.

Speakers cutting out at high volume What causes this. Thats typically meaning the sound cuts out but if the whole radio is shutting off you could be acctually over powering your stock speakers and causeing the radio to trip and reset its self. It has often been seen that once your speaker reaches a certain volume they tend to cut off automatically without any prerequisite warning.

So what I have is a Yamaha RX-V465 AV Receiver 525 watt 105w x5 I HAD a practically new pair of Polk Monitor 70 series 2 Tower speakers which were rated at 275w I sold them last week. And if i left it at a high volume for to long the crossover would cut off. Install went great sounds and looks great as well.

If you put to big of speakers on the radio that the radio cant push the radio over heats and suts off to protect itsself. If the receiver stays on please go to Step 3. Unfortunately you have 3 options and none includes keeping your current equipment as is if you like it loud option 1 keep receiver and change speakers for something a little easier to drive.

As the title says my Onyko Receiver is shutting down when I turn the volume up to a medium level. The only other cause is. Im using in wall speaker wire setup.

If its minor theyll muddle on but at higher output its enough to short and shut down some sort of protector circuit. It was shutting off after a few seconds going into protection mode. Jan 16 2016.

I have checked everything to see if i have it wired right and everything is a go. How I fixed my Yamaha Receiver RX-V765. Stereo shuts off at high volume Thread starter Bigbee246.

And would eventually come back on. Only issue is every time the volume level is at roughly 30 before I can go any higher the radio shuts down and then comes back on. Archive through May 25 2007 - Stereo turns off at high volume.

Plug your device into a different wall outlet. Stereo receiver cuts off. If the receiver shuts off right away the unit will require service.

If you happen to be running 4 ohm speakers or lower the impedance level is dropping too low for your receiver to handle at high volumes. The reason this happens is similar to what was discussed above in the over all audio shutting down at high volumes area. If this doesnt solve the problem unplug everything except a source and try to get the receiver itself to shut down.

Move the unit from its present location to provide better air flow and check for problems. Actually alot of these problems are cause by improper load put on the radio. Sep 18 2001 4 of 13.

Then it shuts off restarts and if Im unable to turn it down in time it shuts off yet again in a continuous cycle. Disconnect all of the speaker wires from the back of the receiver. Your speaker have a nominal 4ohm load and most likely dips lower and it can be very taxing on most receiver if played at high volume for a long period of time.

That might show if you have a bad wire or speaker. Dec 28 2018 3 0. Remove the batteries from the remote control to avoid sending unintentional signals to your device.

If you let this go for too long youll be taking that receiver in for a service call down the road a bit. Turn the receiver on and turn the volume control up to about half way. Car Audio Help 101.

However sometimes your speakers cutting out at high volume make you feel so annoyed. 14G wire Energy Take Classic 51 surround sound speakers for 5 of the channels with included powered subwoofer And. Id suggest buying an unspoiled roll and trying it wo any funny business routing it prettily etc etc and if you can get a friend with a soldering iron to tin the tips so theres no chance of stray wires all the better.

Start date Dec 28 2018. Even if your speakers are 8 ohms they may dip at certain frequencies which may also shut your receiver down if played at a high volume for long enough. Lets say you wire up a subwoofer and one of the speaker wires are left loosely attached to the subwoofer terminal.

While that sub might work at very low volumes it will cut out at higher volumes. But a few. I recently upgraded my stock hu to a pioneer avh-200ex double din dvd receiver.

What Is A Receiver Stereo Barn