Sony Surround Sound System Subwoofer Not Working

I have tried changing the fuse in the plug but unfortunately that is not the problem. Certain speaker settings may disable the subwoofer.

Sony Dav Dz100 Home Theatre System By Sony 169 00 Add This Home Theater System To Your Existi Sony Home Theatre Home Theater System Electronics Home Theater

The subwoofer outputs no sound while only speaker set B is on.

Sony surround sound system subwoofer not working. The subwoofer on my Sony HT-CT290 has suddenly stopped working. 5 speakers and a subwoofer Works great. In that case you will need to purchase an active subwoofer.

Check each speaker to make sure they are properly connected to the AV receiver. Follow these steps to troubleshoot the issue. Right after turning on the subwoofer set the link settings between the Soundbar speaker and the subwoofer again.

Trying a different speaker setting may resolve the issue. I have checked my external subwoofer is working by connecting to a different device. If there is no sound output from the Sound Bar subwoofer refer to the No sound is output from the Subwoofer article.

Z213 speackers work subwoofer dont help. Ensure the subwoofer has not been muted. Verify connections turn on the subwoofer and set the volume.

It is 15months old and I have spoken to Sony but it was only covered by a 12 month warranty typically. Connect one end of the audio cable to the subwoofer audio input connector. Subwoofer to CSub in motherboard not working.

Change the TV audio output setting to PCM and check whether sound is output. If you still have the same problem after changing the sound mode make sure the speakers are securely and properly connected to the AV stereo receiver. This article applies only to specific products andor operating systems.

I hope everyone else in this thread gets the same service. New car subwoofer and amplifier not working. For this option to be enabled Speakers Settings in the TV must on Audio System Auto 1.

After all connections and settings have been verified turn on the subwoofer. Even if Windows detects SONY TV as a sound device in 51 when I play the same DOLBY test files with VLC it only gets stereo sound. If your subwoofer has a standby function turn it off.

If you have the HT-RT5 Soundbar and no sound is output from the surround speaker the following instructions are the same as for the subwoofer. Verify the source that you are playing is encoded in surround sound. Verify if the volume level of the subwoofer is set sufficiently high.

When you play source material that contains no information in the LFE channel the subwoofer produces no sound. Some models have an independent volume level for both Subwoofer and the Bar speaker. If the subwoofer is powered on and adjusted properly you should be able to hear a thumping sound on the subwoofer.

If nothing seems to work you can always reset your system to factory default settings and retry the setup process. Ensure the speaker settings on the stereo system or TV have been configured properly to use the subwoofer. Thank you Sony for the help.

Turn on the TV then your audio device. Consult the instruction manual of the stereo system. Make sure the speakers are configured correctly page 34.

Start the volume low and gradually increase it to determine if the subwoofer is working correctly. If your AV receiver has an Auto Calibration function try using it to setup the appropriate sound settings. The subwoofer green power is on and when I power it off and on again it has the powering up sound but no actual sound at all after that.

Turn on the subwoofer. During periods of mainly dialog most of the sound may come from the center speaker only with audio coming out of the rear speakers when there is background or ambient noise. Your BDV can not support a Dolby Digital Plus audio signal.

I got the subwoofer to another apartment tried another STR-DN1080 and another cable and still didnt work. Turn on speaker set A. Prior to the firmware upgra.

Sony receivers will send a simulated LFE signal to the subwoofer and the SW indicator will light up. Set Surround Sound to OFF when playing a source that is not encoded with a Surround Sound signal. Check the volume level on the subwoofer and receiver or amplifier before sending any audio input.

Unplug the AC power cord of the subwoofer and then plug it in again after one minute. Reset the unit back to factory default settings. SettingsSoundHeadphoneAudio Out is still set to Subwoofer but there is no output.

Increase the volume level on the subwoofer. Nonetheless I have a working subwoofer for my HT-CT290 soundbar system. If input mode of the audio system is set to other than TV or the Home menu is displayed the sound is not output.

Very lightly tap on the center conductor of the other end of the cable. Help troubleshooting why subwoofer isnt working through AV Receiver through optical but is through other inputs. Check the Applicable Products and Categories section of this article before starting these steps.

Surround sound is not present at all times. Perform a Test Tone function to verify if the speakers are working correctly. I only had to ship the subwoofer not the entire soundbar system.

Follow these steps to troubleshoot the issue. Make Bookshelf Speakers work with Logitech Z313 s Subwoofer. If not the audio will be very difficult to hear using a Surround Sound setting.

Verify that the subwoofer is turned ON. Perform a Test Tone operation to verify that all speakers are working. Check your manual for the reset procedure of your product.

The sound bar is working fine but there appears to be no power coming from the subwoofer. XD9305 surround passthrough not working I. STR-DN1080 is set to 51 and I tried both large and small speaker sizes.

If the subwoofer does not have a power cord then it is a passive subwoofer. If the issue still occurs reset or reinitialize the Soundbar. I just upgraded my KD-65A1 to firmware v6285 and there is no sound coming from my external subwoofer.

Press the INPUT or TV button on the remote of the audio device then set the input mode to TV. Verify the subwoofer power cord is plugged into an active AC outlet and that the subwoofer is powered on. If you do not hear a thumping sound then there is a possible service issue with the subwoofer.

If any LED indicator is lit or flashing the power is ON.

Sony Mgongo System Loved By Home Theatre Enthusiasts And Gamers Junk Mail Blog Home Theater System Sony Home Theater System Home Theater

Pin Auf Sono

Sony 5 1 Channel Surround Sound Multimedia Home Theater Home Theater Home Theater Speakers Surround Sound

Bring The Energy And Passion Of The Original Performance Home Sony Speakers Subwoofer Sony

Subwoofer Sony Pascal Subwoofer Sony Bathroom Scale

Sony Dav Dz810 Dvd Home Theatre System Dvd Home Theater System Sony Home Theatre Home Theater

Sony Speaker System With Subwoofer Sony Speaker Speaker System Sony Speakers

Pin On Stuff To Buy

Sony Dav Tz140 Dvd Home Theater System 5 1 Channel 300 Watts Total Hdmi Usb Home Theater Surround Sound Dvd Home Theater System Surround Sound Systems

Sony Bdv N890w Blu Ray Home Theater System W 2 Cable Of High Performance Hdmi Hdmi Gold Tipped Blac Home Theater System Multi Room Speakers Home Theater Setup

Sony Dav Is50 B 5 1 Channel Micro Satellite Home Theater System Black By Sony 395 Home Theater System Sony Home Theater System Samsung Home Theater System